HIKVISION DS-TCP045, Руководство пользователя

Страница: 12 / 93

User Manual of Parking Camera
11
Chapter 2 Installation
Before you start:
Make sure the device is intact and all the components are complete.
Purpose:
The parking camera can be installed on various types of bearing body. The installation
below takes the example of installing the camera on bridge. Make sure the bridge
installation is done before installing the parking camera. Refer to the following steps
for parking camera installation.
The bridge should be thick enough, and the weight capacity of bridge should be 3
times of the total weights of parking cameras at least.
Steps:
1. Punch a hole on the bridge. The diameter of the hole should be a little larger than
that of the stud on the bottom of the parking camera (30 mm).
Figure 2-1 Punch a Hole
2. Install the parking camera. Pass the integration cable on the bottom of the camera
through the hole on the bridge, and embed the stud to the hole.
Figure 2-2 Install Parking Camera
3. Install the clamp nut. Pass the clamp nut of the parking camera through the
integration cable, ring the nut to the stud, and rotate it to the end clockwise to fix
the camera to the bridge.