HIKVISION DS-K2M061, Руководство пользователя

Страница: 4 / 17

Safety Instruction
Dangers
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• An all-pole mains switch shall be incorporated in the electrical installation of the building.
• Do not connect several devices to one power adapter as adapter overload may cause over-heat
or fire hazard.
• If smoke, odors or noise rise from the device, turn off the power at once and unplug the power
cable, and then please contact the service center.
• Shock hazard! Disconnect all power sources before maintenance.
• If the product does not work properly, please contact your dealer or the nearest service center.
Never attempt to disassemble the device yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)
Cautions
• The equipment has been designed, when required, modified for connection to an IT power
distribution system.
• This equipment is suitable for mounting on concrete or other non-combustible surface only.
• The serial port of the equipment is used for debugging only.
• • Install the equipment according to the instructions in this manual.
• To prevent injury, this equipment must be securely attached to the floor/wall in accordance
with the installation instructions.
• No naked flame sources, such as lighted candles, should be placed on the equipment.
• Do not place the device in extremely hot (refer to the specification of the device for the detailed
operating temperature), cold, dusty or damp locations, and do not expose it to high
electromagnetic radiation.
• The device cover for indoor use shall be kept from rain and moisture.
• Exposing the equipment to direct sun light, low ventilation or heat source such as heater or
radiator is forbidden (ignorance can cause fire danger).
• Please use a soft and dry cloth when clean inside and outside surfaces of the device cover, do
not use alkaline detergents.
• Please keep all wrappers after unpack them for future use. In case of any failure occurred, you
need to return the device to the factory with the original wrapper. Transportation without the
original wrapper may result in damage on the device and lead to additional costs.
DS-K2M061 Secure Door Control Unit User Manual
iii