WEB Configuration of DS-3E2300P Series Ethernet SwitchEW
[
选取日期
]
9
2.1.2 Upgrading to the Web-Supported Version
If your switch is upgraded to the Web-supported version during its operation and the
switch has already stored its configuration files, the Web visit cannot be directly applied
on the switch. Perform the following steps one by one to enable the Web visit on the
switch:
Step 1
Connect the console port of the switch with the accessory cable, or telnet to the
management address of the switch through the computer.
Step 2
Enter the global configuration mode of the switch through the command line, the
DOS prompt of which is similar to “Switch_config#”.
Step 3
If the management address of the switch is not configured, please create the VLAN
interface and configure the IP address.
Step 4
Enter the command
ip http server
", to enable Web service.
Step 5
Enter the
username
to set the user name and password of the switch For how to use
this command, refer to the “Security Configuration” section in the user manual.
Step 6
After the above-mentioned steps are performed, you can enter the address of the
switch in the Web browser to access the switch.
Step 7
Enter the command
write
", to save the current configuration to the configuration
file.
2.2 Accessing a Switch through Secure Links
The data between the WEB browser and the switch will not be encrypted if you access a
switch through common HTTP. To encrypt these data, you can use the secure links, which
are based on the secure sockets layer, to access the switch.
To do this, you should follow the following steps:
Step 1
Connect the console port of the switch with the accessory cable, or telnet to the
management address of the switch through the computer.
Step 2
Enter the global configuration mode of the switch through the command line, the
DOS prompt of which is similar to “Switch_config#”.
Step 3
If the management address of the switch is not configured, please create the VLAN
interface and configure the IP address.
Step 4
Enter the command
ip http server
", to enable Web service.
Step 5
Enter the
username
to set the user name and password of the switch For how to
use this command, refer to the “Security Configuration” section in the user manual.
Step 6
Run
ip http ssl-access enable
to enable the secure link access of the switch.
Step 7
Run
no ip http http-access enable
to access the switch through insecure links.
All manuals and user guides at all-guides.com
all-guides.com