User Manual of Network Speed Dome
99
6.
Set the detection target for the region entrance detection. You can select human,
vehicle, or all (human &vehicle) as the detection target from the dropdown list.
If Human is selected, only human beings will be identified as detection objects
and as well as Vehicle.
7.
Click the
button to set the arming schedule. Refer to
Step 2
in
Section 6.6.1 Configuring Motion Detection
8.
Select the linkage methods for region exiting detection, including Notify
Surveillance Center, Send Email, Upload to FTP, Trigger Channel, Trigger Alarm
Output and Smart Tracking. Please refer to
Step 3
in
Section 6.6.1 Configuring
9.
Click
button to save the settings.
Chapter 7 Record Settings
Before you start:
To configure record settings, please make sure that you have the network storage
device within the network or the storage card has been inserted in the corresponding
card slot. Refer to the installation guide for the location of the storage card slot.
7.1 Configuring NAS Settings
Before you start:
The network disk should be available within the network and properly configured to
store the recorded files, log files, etc.
Steps:
1. Enter the NAS (Network-Attached Storage) Settings interface:
Configuration > Advanced Configuration > Storage > NAS
2. Select the NAS type as NFS or SMB/CIFS. If you select SMB/CIFS, you need to enter
the User Name and Password.
For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (using a
minimum of 8 characters, including upper case letters, lower case letters,
numbers and special characters) in order to increase the security of your
product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
© Hikvision
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]