HIKVISION DS-2DF5220S, Быстрый старт, Страница: 4 / 112

3
the product and keep it away from children.
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical
attention.
CAUTION: Risk of explosion if the battery is replaced by an
incorrect type.
Improper replacement of the battery with an incorrect type
may defeat a safeguard (for example, in the case of some
lithium battery types).
Do not dispose of the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may result in an
explosion.
Do not leave the battery in an extremely high temperature
surrounding environment, which may result in an explosion or
the leakage of flammable liquid or gas.
Do not subject the battery to extremely low air pressure,
which may result in an explosion or the leakage of flammable
liquid or gas.
Dispose of used batteries according to the instructions.
Installation
Never place the equipment in an unstable location. The
equipment may fall, causing serious personal injury or death.
Cautions
Fire Prevention
No naked flame sources, such as lighted candles, should be
placed on the equipment.
The serial port of the equipment is used for debugging only.
Do not connect several devices to one power adapter as an
adapter overload may cause over-heating and can be a fire
hazard.
Hot Surface
CAUTION: Hot parts! Burned fingers when handling the parts.
This sticker is to indicate that the marked
item can be hot and should not be
touched without taking care. Wait
one-half hour after switching off before
handling parts.
The device with this sticker is intended for installation in a
restricted access location. Access can only be gained by
service persons or by users who have been instructed about
the reasons for the restrictions applied to the location and
about any precautions that shall be taken.
Installation
Install the equipment according to the instructions in this
manual.
Make sure that the power has been disconnected before you
wire, install, or disassemble the device.
To prevent injury, this equipment must be securely attached
to the ceiling in accordance with the installation instructions.
Transportation
Keep the device in original or similar packaging while
transporting it.
Do not drop the product or subject it to physical shock.
Power Supply
Refer to the device label for the standard power supply.
Please make sure your power supply matches with your
device.
Maintenance
If the product does not work properly, please contact your
dealer or the nearest service center. We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.
Cleaning
Please use a soft and dry cloth to clean the interior and
exterior surfaces. Do not use alkaline detergents.
Using Environment
When any laser equipment is in use, make sure that the
device lens is not exposed to the laser beam, or it may burn
out.
Do not aim the lens at the sun or any other bright light.
To avoid heat accumulation, good ventilation is required for a
proper operating environment.
DO NOT expose the device to extremely hot, cold, dusty,
corrosive, saline-alkali, or damp environments. For
temperature and humidity requirements, see device
specification.
DO NOT expose the device to high electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device, immediately
turn off the power, unplug the power cable, and contact the
service center.
Time Synchronization
Set up device time manually for the first time access if the
local time is not synchronized with that of the network.
Visit the device via web browser/client software and go to
time settings interface.
1 Overview
1.1 Type A
3
4
5
6 7 8
2
1
No. Description
1 Reset
2 Memory Card Slot
3 Joystick
4 Dial
5 Power
6 Network Interface
7 Audio Output
8 Audio Input
1.2 Type B
1.2.1 Front Interface
2
3
1
No. Description
1 Lens