3.
Attach the mounting base of the type I camera to
the ceiling and secure the camera with supplied
screws.
Figure 2. 2
Secure
the camera to the ceiling
Note:
In the supplied screw package, both self-tapping
screws and expansion blots are contained.
If the wall is cement, expansion blots are required
to fix the camera. If the wall is wooden,
self-tapping screws are required.
4.
Route the cables through the cable hole (optional),
or the side opening.
5.
Connect the corresponding power cord and video
cable.
6.
Power on the camera to check whether the image
on the monitor is gotten from the optimum angle.
If not, adjust the camera according to the figure
below to get an optimum angle.
1).
Loosen the No.1 adjusting screw to adjust the
pan position (0° to 360°).
2).
Tighten the No.1 adjusting screw.
3).
Loosen the No.2 adjusting screw to adjust the
tilting position (0° to 180°).
4).
Tighten the No. 2 adjusting screw.
5).
Loosen the No.3 adjusting screw to adjust the
rotation position (0° to 360°).
6).
Tighten the No.3 adjusting screw.
0° to 360°
3
2
1
0° to 360°
0° to 180°
Figure 2. 3
3-Axis Adjustment
Installation of Type II camera
Steps: