Figure 2-7
Secure Base to Ceiling
6.
Align the screw hole with the triangle mark to install
the camera back to the base and secure it.
Triangle
Mark
Figure 2-8
Install Camera Back
7.
Connect the cables.
8.
Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure
below.
Rotation Position
[0° to 360°]
Tilt Position
[0° to 75°]
Pan Position
[0°to 360°]
Figure 2-9
3-Axis Adjustment
1).
Rotate the enclosure to adjust the pan position
[0° to 360°].
2).
Move the main body up and down to adjust the
tilt position [0° to 75°].
3).
Rotate the main body to adjust the rotation
position [0° to 360°].
9.
Tighten the set screw to finish the installation.
2.2.2
Ceiling Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Steps:
1.
Loosen screws to take apart the junction box.
2.
Paste the drill template for junction box to the place
where you want to install the camera.
3.
(Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
4.
(Optional) Drill the cable hole, when the cables are
routed through the ceiling.
5.
Secure the junction box body on the ceiling with
three PA4 × 25 screws that come with the junction
box.