Figure 2-3
Fix the Camera to the Junction Box Cover
6.
Secure the junction box body on the wall with three
PA4 × 25 screws (supplied).
Figure 2-4
Secure the Junction Box on the Wall
7.
Route the cables through the bottom cable hole or
side cable hole of the junction box and connect the
cables.
8.
Fix the junction box cover on its body with three
PM3 × 16 L6 screws.
Figure 2-5
Fix the Cover to Its Body
9.
Refer Step 6 of Section 2.1.1 to finish installation.
2.2
Installation of Type II Camera
2.2.1
Ceiling Mounting without Junction Box
Steps:
1.
Paste the drill template (supplied) to the installation
location.
2.
(Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
3.
Install the camera to ceiling.
i.
Secure the installation plate to the ceiling with
three PA4 × 25 screws (supplied).
ii.
Fit the camera onto the installation plate.
iii.
Turn the camera as the figure below until it snaps
into the installation plate.
Figure 2-6
Install the Camera to Ceiling
4.
Connect the power cord and video cable.
5.
Power on the camera to adjust the view angle
according to the figure below.