– 18 –
– 18 –
Fig.
Q
Folding the stand
TRANSPORTATION AND STORAGE (FIG. R, S)
Fold the four stand legs using the instructions in section
“
FOLDING THE STAND
” on page 17, hold the stand
handles with both hands and slowly raise the stand for
transportation and storage. (Fig. R)
MAINTENANCE
WARNING
•
When service the stand, use only identical HiKOKI
replacement parts. Use any other parts may cause
hazards or product damage.
Repairs should be conducted only by a HiKOKI
authorized service center.
•
Always wear safety goggles or safety glasses
with side shields and dust mask during power tool
operation or when blowing dust.
•
Ocassionally check the saw mounting brackets,
making sure the mounting brackets are tight by
following “
ADJUSTING THE SAW MOUNTING
BRACKETS
” on page 16.
WARNING
•
Do not transport the unfolded stand with a miter saw
mounted on it.
•
When transporting the stand in a vehicle, securely tie
it down to prevent movement and possible damage.
•
When storing the stand, make sure that the miter
saw is dismounted from the stand and the stand
is lying down
fl
at on a stable surface. Never store
the stand in upright position or lean it against wall.
(Fig. S)
Fig.
R
Fig.
S
GENERAL MAINTENANCE
Remove the miter saw when servicing or cleaning the
stand. Use clean cloths to remove dirt, dust, oil, grease
and etc. Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use.
WARNING
Do not use the brake
fl
uids, gasoline, petroleum-based
products, penetrating oils and so on to contact with
plastic parts. Chemical can damage, weaken or destroy
plastic which may cause serious personal injury.
000Book̲UU240F.indb 18
000Book̲UU240F.indb 18
2019/12/26 10:14:10
2019/12/26 10:14:10
