English
28
5. How to use the anchor adapter
(1) Install the automatic boring anchor in the anchor adapter
(
Fig. 8
).
(2) Turn ON the switch and drill a base hole with the
automatic boring anchor. (
Fig. 9
)
At the start of the hole-drilling slightly tilt the rotary
hammer to determine the hole position.
(3) After cleaning out dust with a syringe, attach the plug to
the anchor tip and drive in the anchor with a manual hammer.
(4) After driving in the anchor, use the drift key to separate the anchor. (
Fig. 10
)
(5) By employing a manual hammer or pliers, snap o
ff
the tapered portion of the anchor.
(
Fig. 11
)
CAUTION
Since the snapped-o
ff
tapered portion will
fl
y about, pay attention to the snapping
direction.
Fig. 9
Hole depth
Fig. 10
Drift key
Wrench out
Fig. 11
6. How to use the drill bit (taper shank) and the taper shank
adaptor.
(1) Install drill bit with taper shank in the taper shank adaptor.
(
Fig. 12
)
(2) Turn the power on and drill a base hole.
(3) After cleaning out dust with a syringe, attach the plug to the
anchor tip and drive in the anchor with plug to the anchor
tip and drive in the anchor with a manual hammer.
(4) To remove the drill bit with taper shank, insert a cotter into
the slot of the taper shank adaptor, place supports under the
Rotary Hammer and tap the cotter with a manual hammer.
(
Fig. 13
)
Fig. 8
Plug
Snap o
ff
this portion after driving
in the automatic boring anchor.
Fig. 12
Taper shank adaptor
Drill bit
(Taper shank)
Fig. 13
Cotter
Support
Taper shank
adaptor
000Book̲DH40SC̲ChS.indb 28
000Book̲DH40SC̲ChS.indb 28
2018/03/27 15:54:54
2018/03/27 15:54:54