Higo 5528, Инструкция по эксплуатации

Страница: 24 / 27

HAG-55/450
5528
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański, tel/fax:+48 58 56 300 80
www.ega.com.pl
22
Blow switch chips
Jig saw has a function blow-chips (see 2, Fig.7) allowing blow to the front chips from the cut.
Setting the left is a blow-off (blocking blow), and the setting is a blow right on.
Operation
Note:
Jig saw
’s base must be flat pressed against the surface of the workpiece.
Failure to do so may be cause breakage of the blade or cause serious injury.
When cutting or curvature of the eruption, the tool should be very slow to move forward. Too
much pressure can cause inclination of the cutting surface or blade fracture.
Turn on the device without touching the blade of the cut material and wait until the blade
reaches the maximum speed step. Then set foot flat on the workpiece and gently move the
tool forward along the previously fixed line.
Cutting top-down and eruption
Starting cut from the middle element, you must first drill a hole with a diameter of 12mm and
make sure the blade is freedom of movement.
While cutting sharp curvatures reduce your speed jig saw.
Warning!
Jig saw can begin to move forward along a predetermined line only when the blade is fully
inserted into the material, and the base starts to adhere to its surface.
Metal cutting
When cutting metal wear suitable cutting oil.
In the course of cutting, the blade should be regularly sprayed with oil, which will reduce the
wear of the blade.
Maintenance
Warning! Before starting any activity, control and maintenance, the tool must be switched off
and disconnected from the network.
In order to ensure a long trouble-free and safe operation, all repair and maintenance work,
such as. Inspection and replacement of carbon brushes they should be carried out in
specialized service.
The tool should be stored in a safe place along with the instruction manual and accessories.