Overview
– The RocketRAID mini‐SAS 3Gb/s series controller supports data single
configuration. A data single configuration is a single hard drive connected to the
RocketRAID mini‐SAS 3G series controller. This document will guide you on how to
configure and setup your hardware to support data single configurations.
The hardware and software pre‐requests are listed below:
•
RocketRAID mini‐SAS 3Gb/s series HBA
•
RocketRAID mini‐SAS 3Gb/s for Mac drivers
•
Mac Pro system 2006 to Present
•
Multiple or single bay SATA/SAS external storage
•
Mac OS X 10.5.x and above
System
Requirements
Mac
Pro
Hardware:
Intel‐based Mac with an available PCIe 2.0 or 1.0 slot capable
of supporting an x8 (8‐lane) length PCIe card. For optimal performance, use a PCIe
1.0 slot running at x8 speeds or greater.
Slot recommendations for the RocketRAID mini‐SAS 3G series controller.
Mac Pro Model Core / CPU Speed GHz
EFI
Slot Number
2006
Quad Core / 2.0, 2.66, 3.0
32‐bit
3,4
2006
Eight Core /3.0
32‐bit
3,4
2008
Quad Core / 2.8
64‐bit
2,3,4
2008
Eight Core/ 2.8, 3.0, 3.2
64‐bit
2,3,4
2009
Quad Core / 2.66/2.93/3.33
64‐bit
2,3,4
2009
Eight Core / 2.26, 2.66, 2.93
64‐bit
2,3,4
2010
Quad Core / 2.9, 3.2
64‐bit
2,3,4
2010
Six Core / 3.3
64‐bit
2,3,4
2010
Eight Core / 2.4
64‐bit
2,3,4
2010
Twelve Core / 2.66, 2.93
64‐bit
2,3,4
Operating
System:
Mac OS X 10.5.x
Before, installing the RocketRAID mini‐SAS 3G series controller make sure the
computer is turned off and unplugged from its power source. Take appropriate
electrostatic discharge precautions.
Your computer is a static‐sensitive device. It is susceptible to invisible damage if not
protected during installation.
We recommend proper grounding by using a grounding strap. Make sure to work in
a clean and static‐free area, and avoid wearing clothing that retains static charges.