Highlight Synergy 0.5, Руководство по эксплуатации

Страница: 38 / 57

Maintenance Synergy 0.5 Turntable Stretch Wrapper Operation Manual
Highlight Industries, Inc. ● 2694 Prairie SW, Wyoming, Mi 49519 ● 1-800-531-2465
37
Turntable Bearing Lubrication Table
The main turntable bearing should be lubricated with clean grease that conforms to NLGI
EP-2 penetration. Wipe fittings clean before and after lubrication; rotate the turntable while
lubricating. Thereafter, use the following recommendation for periodic lubricating:
Shift Operation Times Per Year
Single Shift 4
Double Shift 8
Triple Shift 12
Reducer
All gear reducers contain lubricating oil. A high-grade lubricant is required which is stable,
anticorrosive, and highly resistant to oxidation. Drain and replace the oil in these reducers
using the following recommended directions:
1. Remove the drain plug and drain the oil.
2. Replace the drain plug.
3.
Remove the ‘level’ plug and ‘vent’ plug.
4.
Fill the reducer through the ‘vent’ port.
5.
Allow the excess to run out from the ‘level’ port.
6.
Replace the ‘level’ plug.
7. R
eplace the ‘vent’ plug.
Sprockets and Chains
All sprockets should be inspected for wear, and chains should be checked for proper
tension and lubrication on a periodic basis. To do this procedure, the chain guards will have
to be removed. If the slots in the reducer mount plate do not allow you to tension the chain,
the chain is probably stretched and in need of replacement. Failure to do so will lead to
premature sprocket failure. Any general-purpose chain lube should be sufficient for
lubrication. Replace chain guards when preventative maintenance is complete.
Miscellaneous Pivot and Rotating Bearings
All other bearings not mentioned previously should be greased bi-monthly using Mobile EP-
2 or equivalent.