PREDATOR XS TURNTABLE STRETCH WRAPPER OPERATION MANUAL
HIGHLIGHT INDUSTRIES, INC. ● 2694 PRAIRIE SW; WYOMING; MI 49519 ● 1-800-531-2465
II-1
MACHINE PLACEMENT
MACHINE PLACEMENT
MACHINE PLACEMENT
MACHINE PLACEMENT
Receiving and Inspections
The Predator Turntable Stretch Wrapper has gone through quality control tests at the factory
before shipment. Upon receiving, please do the following:
1. Inspect the entire machine for visual damage during shipment. If found, immediately report
this damage to the truck line. Highlight Industries, Inc. has taken every precaution during
the packaging and loading of this equipment. However, it is YOUR RESPONSIBILITY to
inspect for damage before installation.
2. Make sure the part or serial number indicated on the machine corresponds with the part
number of your order.
Positioning of the Machine
Place the Predator Turntable Stretch Wrapper close to an area where you will be wrapping your
pallet loads. Make sure that there is sufficient room to load/unload the machine and that you do
not stretch the wiring cable. Remember, you will need to provide electrical service to a 120 VAC,
15-Amp outlet.
Floor Weight Bearing/Stress Tolerance
The floor must be able to bear the weight of the machine, the weight of the maximum load, plus a
safety factor. The floor must also be able to tolerate the stress of the machine’s operation. If the
fork trucks will operate on the same weight bearing area, add the weight of the trucks to the
weight bearing stress tolerance requirements.
The Predator can be installed on any type of floor constructions that meets the weight bearing and
stress tolerance requirements.
WARNING
The Predator must be anchored securely to the floor, using the type
of anchor recommended for your floor.
