HIGHLEAD GC24698-25L, Инструкция по эксплуатации

Страница: 3 / 37


Preparation for operation
：
1. Safety precautions
：
1) When turning the power on, keep your hands and fingers away from the area around/under the needle
and the area around the pulley.
2) Power must be turned off when the machine is not in use, or when the operator leaves the seat.
3) Power must be turned off when tilting the machine head, installing or removing the “V” belt, adjusting
the machine, or when replacing.
4) Avoid placing fingers, hairs, bars etc. near the pulley, “V” belt, bobbin winder pulley, or motor when the
machine is in operation.
5) Do not insert fingers into the thread take-up cover, under/around the needle, or pulley when the machine
is in operation.
6) If a belt cover, finger guard, eye guard are installed, do not operate the machine without these safety
devices.
2. Precautions before starting operation
：
1) Never operate the machine before filling the machine’s oil pan.
2) When a new sewing machine is first turned on, verify the rotational direction of the pulley with the
power on.
3) Verify the voltage and phase (single or three) with those given on the machine nameplate.
3. Precautions for operating conditions
：
1) Avoid using the machine at abnormally high temperatures
（
35
℃
or higher
）
or low temperatures
（
5
℃
or
lower
）
.
2) Avoid using the machine in dusty conditions.

Cautions on use
：
1. Lubrication (Fig.1, Fig.2)
When a new sewing machine is
used for the first time, or sewing
machine left out of use for a long time is
used again, replenish a suitable amount
of oil to the portions indicated by arrow
in the fig.
Note: Filling the oil to the fount
timely (Fig.3). Use white spindle oil.
—
1
—