HIGHLEAD GC20618 Series, Инструкция и каталог запасных частей

Страница: 7 / 54

—
4
—
tool” in the hole” A”, then remove the tool.
2) Adjust of “Down” position
When the pedal is “Neutral” the machine stops
at “Down” position. If the marks deviate large
than 5 mm, adjust as follows.
a) Disconnect the plug (12 pins) of cable from
the machine head
b) Run the machine and stop at “Down” position.
c) While holding the pulley, insert the “adjusting tool” in the hole “B”, then remove the tool.
3) Confirm the stop operation, then set the plug (12 pings) coming from the machine head into the
receptacle.
CAUTIONS ON USE
1. Oiling (1)
Fill the oil reservoir with oil up to “H” mark.
Oil level should be periodically checked. If oil
level is found below “L” level replenish oil to
“H” level . For oil, Use white spindle oil
1.
2. Oiling (2)
When a new sewing machine is used for
the first time, or sewing machine left out
of use for considerably long time is used
again, replenish a suitable amount of oil to
the portions indicated by arrow in the below
figure
3.
Oiling condition
See dripping of oil through the oil sight
hole to check oiling condition during operation.