Highland Ridge RV 2015, Руководство пользователя

Страница: 46 / 120

SECTION 4 TOWING & SET-UP HIGHLAND RIDGE TOWABLE
4-8
K
EYS
/L
OCKS
Several keys are provided when you purchase your RV. Most keys have an
individual key number stamped on the plate. Record these key numbers and keep
the information in safe place. You can order a key blank from your RV dealer to
have duplicate keys made. If you lose the keys, contact your RV dealer or a
locksmith for assistance.

NOTE: Locks on entrance and baggage doors need biannual lubrication using
a light coat of silicone spray. Conditions such as rain, salt, dust and pollution may
increase the maintenance needs.
K
EYLESS
E
NTRY
(
IF SO EQUIPPED
)
Battery Installation
The keyless entry system uses (4) AA batteries for operation. We do not
recommend zinc carbon batteries for this application.
Fresh batteries should be installed as necessary. Battery Life is highly dependent
upon battery quality, usage, and environment (temperature). Remove the
batteries if the lock will not be used for an extended period of time.
1. Remove the (2) screws from the battery compartment Lid. These screws are
very small, caution should be used when removing and re-installing the
screws to prevent losing them.
2. Install the AA batteries in accordance with the orientation shown in the battery
compartment.
3. Install the battery compartment lid by aligning the (3) tabs on the lid with the
(3) slots on the inside plate assembly. These tabs act as a hinge for closing
the battery compartment lid.
4. Install the (2) screws to attach the battery compartment lid to the inside plate
assembly.
Description
The keyless entry system is a 4 touch pad button programmable deadbolt lock.
The 4 buttons are labeled “1/2”, “3/4”, “5/6”, “7/8”. The button labeled “1/2” is the
same button whether the number 1 or 2 is desired. Please note this handle uses
Touch Technology. The buttons are activated by touch and do not require
pressing them. Touch the button and lift your finger to enter your code.
Operation
The keyless entry system incorporates proximity sensing to determine when you
want to activate the lock. To operate the lock you must first “wake up” the lock.
To “wake up” the lock you must touch the area next to the buttons. The buttons
will illuminate once the Touch Pad is activated. This indicates the Touch Pad is
ready for the code to be entered.
Preset Factory Code
The keyless entry system has a factory set code of 3,7,1,5 followed by the Enter
button. The Enter button is the last button with the picture of the key, and must be
touched after entering the code. The factory code resets every time the batteries
are removed for a least 10 seconds.