______________________________________________________________________________________
12
www.hightechpet.com
High Tech Pet Products, Inc.
'RZQORDGWKH%OXHIDQJ$SSRQ\RXUVPDUWSKRQHWRWXUQRQWKH
IHDWXUHVLQWKHFROODU
6FDQWKH45FRGHEHORZ
RU
6HDUFK
%OXHIDQJ'RJ7UDLQHUDQG)LWQHVV
LQ\RXU$SS3OD\6WRUH
___________________________________________________________________________________________
High Tech Pet Products, Inc.
www.hightechpet.com
21
The TX-
casing is assembled in two parts, the mounting base and the
electronics console. In the package, they are assembled together. You must
Ôijkj\gXiXk\k_\dflek`e^YXj\]ifdk_\Zfejfc\%K_`j`j\Xj`cp[fe\Yp
simply pulling them apart. Hold the mounting base in one hand and the
Zfejfc\`ek_\fk_\iXe[ÔidcpglccXgXik%K_\jeXgZcfjli\jn`ccj\gXiXk\%
A. Using the four mounting screws provided, mount the Mounting Base in
its desired location.
B. If you have purchased the optional back-up battery, install it in the back
of the electronics console by plugging in the connector and snapping
the battery into place. If you did not purchase the back-up battery it is
easy to install it at a later date should you choose to do so.
C. Line up the snap in mounting posts in the Mounting Base with the
_fc\j`ek_\<c\Zkife`Zj:fejfc\Xe[glj_Ôidcplek`ck_\knfg`\Z\j
snap together.
AC Adapter
: Plug the 16 VDC adapter into a standard 115 Volt outlet and
connect the DC plug into the receptacle on the lower right of the Base
Station Transmitter.
STEP 4: Test The Receiver Collar Radio Function
You should test the receiver by installing a 24 inch long test loop of wire
across the quick connect cable terminals. Set the Power Boost switch
to normal (NOR) and switch on the Base Station Transmitter. Bring the
receiver close to your test loop. A beeping sound emitted by the receiver
collar indicates the system is working properly. Note that with such a short
loop the range will only be a few inches.
STEP 5: Prepare Twisted Wire Lengths First
Prepare the twisted lengths of wire. From your system layout sketch,
determine the length required for each twisted pair. Cut two equal lengths
of wire for each required twisted pair. With the pair of wires side by side,
put one end of each wire in a power drill and spin the wires until there is
approximately one twist per inch of wire. Do not over-twist because this
could damage the wire. Repeat for each required pair.
STEP 6: Layout the Boundary Wire Above Ground
Before burying your boundary wire, we recommend that you run the
complete loop of wire, make all connections and use the receiver collar to
fully test the system with the wire above ground. Referring to the sketch
you made of your system layout, run and connect the wire loop above
ground, connect it to the Transmitter Base Station.
Installation Tip
: Leave a little (about 15 inches) slack in the wire
periodically along the perimeter and at the corners of the layout so you
have a little extra wire when needed to repair a break in the loop. Wind
the 15 inch slack into a 5 inch diameter coil and bury it with the wire.
:_ffj\cfZXk`fej]fik_\jcXZbk_XkXi\\Xj`cp`[\ek`Ô\[YpXk\iiX`e
feature and make a map of them.
