High End Systems studio color, Руководство пользователя

Страница: 37 / 114

Chapter 1 Installation and Setup 1-11
Introduction
Inst
allation and Set
up
1
Data Cabling
To connect the data cables, complete the following procedure:
1. Connect the data cable from the controller to the
Data In
connector on the side
of the fixture. Refer to Figure 1.10.
Figure 1.10. Data In and Data Out Connectors
2. Daisy chain additional fixtures by connecting the
Data Out
connector to the
Data In
connectors on subsequent fixtures. Refer to Figure 1.11.
Figure 1.11. Daisy Chaining Fixtures
3. Install a terminator in the
Data Out
connector of the last fixture on each DMX
link.
4. Connect AC mains (power) and turn on the breaker located next to the power
cord on the side of each fixture. Refer to Figure 1.10.
5. The fixture(s) will home and run through a built in self-test.
Note: if any error messages are present on the display, refer to Troubleshooting in
Appendix A.
DA TA IN DA TA OU T
PO WER
DA TA IN DA TA OU T
PO WER
DA TA IN DA TA OU T
PO WER
S
tud
io
C
olo
r
DAT A L INK
OU T
1 2 3 4 5 6 7 8
PERSON ALIT Y SLAVE M ASTER RS- 232
SERIAL POR T 1-6
ANAL OG INPUT S
7-12
REM OT E
ENABLE F USE
CAUT IO N
v oltage s elect
1 2 3 4
A B
M ID I
IN OUT ST ER EO
AU DI O
IN PU T
1.6 a mp
11
5
L
R
S
tud
io
C
olo
r
S
tud
io
C
olo
r
DMX controller
to additional
fixtures