2
12
Installation
Method 1: Installation with Stand
At first remove carefully the
mounting frame of the
monitor's rearside. Then slide
the monitor's mounting slot
(A) on the fixing plate (B)
from the mounting stand.
Ensure thereby a propper
alignment of the fixing plate
in the mounting slot and
don't tilt.
Adduct the knurled head screw
(C) of the stand, after you have
found the right position by
sliding around. The viewing
angle of the Monitor could be
adjusted by the setscrew (D).
A
B
C
Mount at first the stand at
an appropriate position.
f.i. on the dashboard with
the supplied screws.
Observe by any means,
that you don't damage
wires, cables or other pre-
installed parts of the
vehicle.
D
Method 2: Installation in Headrest
Cut out a sufficient mounting
hole in the headrest (B). Use
the inner dimensions of the
mounting frame as draft. Then
lead the A/V-Cable from the
Monitor through the big hole
(C) in the mounting frame and
through the hollow attachment
bar of the headrest.
Depending of the type of your
car, you should fix the
mounting frame (D) with the
attachment bars on the
inside.Then insert carefully the
Monitor in the mounting frame.
After all, slide the headrest
back into the seat and connect
the Monitor's A/V Cable with
the distribution box.
Thereby a installation with
the mounting frame (A) is
suggested. At first
consider the right position
of the separate A/V distri-
bution box, especially
when a additional second
Monitor should be
installed. Ensure for
suffizient lengths of all
cables and wires.
A
C
B
D
