FUSE
The inserted fuse protects the amplifier from electrical shorts and capacity overload. If you need to replace the factory-provided fuse
observe by any means to keep the same fuse rating (30 A).
1
2
3
BEFORE THE CONNECTION
For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Attend the sufficient profile
section (at least 10 mm
2
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after the
installation, because loosely connections may cause malfunctions, unsufficient power supply or interferences. We reccomend therefore the
HiFONICS HF10WK
wirekit.
BATT+12V
Connect the BATT+12V-terminal with the +12V pole of the vehicle’s battery. Use therefor a suitable cable with a sufficient cross section
(min. 10 mm
2
) and install a additional in-line fuse. For safety reasons the distance between the fuseblock and the battery must be shorter
than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished.
REM (TURN-ON SIGNAL)
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your headunit with the REM-terminal of the amplifier.
Use therefor a suitable cable with a sufficient cross section (0,5 mm
2
). Thereby the amplifier will turn on or off automatically with your
headunit. If you use the High Level Inputs instead of the RCA LEVEL INPUT, it’s not mandatory to use a turn-on-signal (Please observe
therefore section 8 on the next page).
4
GND
Connect this GROUND terminal with a suitable contact ground point on the vehicle’s chassis. The ground wire must be as short as possible
and must be connected to a blank metallic point at the vehicle’s chassis. Ensure that this ground point has a stable and safe electric
connection to the negative “–”pole of the battery. Check this ground wire from the battery to the ground point if possible and enforce it, if
required. Use a ground wire with a sufficient cross section (at least 10 mm
2
) and the same size like the plus (+12V) power supply wire.
ELECTRICAL INTERCONNECTION
ENG
Before you start with the installation of the sound system, disconnect by any means the GROUND connection wire
from the battery, to avoid any risk of electric shock and short circuits.
REFERENCE NOTE
FUSE
POWER
INPUT
1
2
3
4
