Hifonics BRUTUS BRE100.2, Руководство пользователя

Страница: 7 / 17

POWER INPUT
GND REM BA
TT+12V
SPEAKER OUTPUT RIGHT LEFT
- + - +
BRIDGED
FUSE
HP
FULL
LP/BP
10Hz 15KHz
30Hz 150Hz
0dB 10dB
6V 0.2V
REMOTE
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
POWER
X-OVER
PROTECT
LINE INPUT
L R
L
R
LINE OUT
REMOTE TURN-ON
CHASSIS GROUND
TO B12v
VIA FUSE
MONO SPEAKER
or SUBWOOFER
POWER INPUT
GND REM BA
TT+12V
CH 1/2 SPEAKER OUTPUT CH 3/4
RIGHT LEFT
RIGHT LEFT
- + - + - + - +
BRIDGED
BRIDGED
FUSE
LINE INPUT
REMOTE
POWER PROTECT
LINE OUT
HI FULL
LP/BP
HI FULL
LP/BP
6V 0.2V
10Hz-15KHz
30Hz-150Hz
0dB-10dB
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
X-OVER 1
/2 CH
6V 0.2V
10Hz-15KHz
30Hz-150Hz
0dB-10dB
X-OVER 3
/4 CH
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
MODE
CH2-CH4
L R
L
R
L R
CH1/2
CH3/4
BRE60.4 / BRE100.4 4-CHANNEL AMPLIFIER APPLICATIONS
5
Front/Rear high pass, using a 2 channel amplifier for mono sub bass
Channels 1/2: The combination of a 2 and a 4 channel amplifier, utilizing their built in
- HI PASS: 100 Hz crossovers, makes it a snap to put together a full system with front and rear
highs, with mono sub bass.
LOW PASS: N/A
Interconnect cable checklist:
Channels 3/4:
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
- HI PASS: 100 Hz
the inputs of the 4 channel amplifier as shown.
- LOW PASS: N/A
- Also connect the LINE OUT of the 4 channel amplifier to the LINE INPUT of the
2 channel amplifier as shown.
2 channel bass amplifier:
- HI PASS (Subsonic filter): 10 Hz to 40 Hz
Mono bass woofer wiring:
- LOW PASS: 80 Hz
Connect the mono speaker positive terminal to the LEFT +, and its negative
terminal to RIGHT -.
Please note that these frequency points are suggestions only. Refer to the
loudspeaker manufacturer specifications and the section
“Setting up systems
Switch setting checklist: after installation for best performance”
4 channel highs amplifier:
- 1/2CH X-OVER:
HI
Level control checklist:
- 3/4CH X-OVER: HI
- Refer to the section “Setting up systems after installation for best performance”
2 channel bass amplifier: Minimum final loudspeaker impedances:
- X-OVER switch: LP/BP
- 2 ohm per channel in stereo mode.
- 4 ohm mono bridged.
Crossover frequency control checklist:
- 4 channel highs amplifier:
STEREO
INTERCONNECT
RCA CABLE
BRUTUS
BRUTUS
ELITE
ELITE