Setup
Common System Setup
Quick Start
Installation Guide
The MODE switch will sum or combine the right
and left channel signals in the 2CH position to
improve bass performance when bridging the
amplifier to mono. Use the 4CH mode when
driving four full range speakers.
The XOVER Mode switch sets the type
of crossover that will be active. 4 channel
models will have two switches, one for each
set of channels.
The HPF(high pass filter) control will limit the
output below the selected frequency. This
is typically used to protect midrange and hi
frequency speakers from damage and to
allow a smooth transition from a subwoofer.
The LPF(low pass filter) control
will limit output above the selected
frequency. This is used to allow
a smooth transition to the higher
frequency speakers.
1.
If possible, with the source unit off, confirm that the primary volume control is
turned down (counter clockwise).
2.
Turn on the source unit (CD, or MP3 player). Re-confirm that the volume is
turned down. Make sure the source unit controls; balance, fader, bass and
treble are all set to center or “0” adjustment. Make sure that the green LED on
the end of the amplifier is illuminated.
3.
Play a clean musical selection of which you are very familiar. CD is preferred.
Do not use radio signals for level setting. Hit play and start turning the volume
of the source unit up.
4.
Stop increasing the source unit volume when you reach 3/4 (about 75%) or until
you hear speakers begin to slightly start producing distortion.
5.
Increase the amplifier level (clockwise) until distortion is heard, then back
the level down (counter clockwise) until the distortion is eliminated. Small
adjustments may need to be made to balance the levels of multiple amplifiers.
The Bass EQ control will increase the power
output at 45Hz for more pronounced bass.
Exercise caution when using this control.
Increase the level in small amounts until
distortion is noticed, then back off a little.
Some models include a bass
remote. Avoid adjusting the bass
remote while operating vehicle.
Input Mode
Xover Mode
High pass
Adjustment
Low pass
Adjustment
Bass Boost
Remote Level
Control
4ch - Full Range
4ch - Mixed Mono
Mono
A
B
C
D
E
F
This is a critical step to insure your amplifier
is properly adjusted to match the signal
output level of your source unit.
THIS IS NOT A VOLUME CONTROL!
Level Setting
G
WARRANTY
Maxxsonics USA Inc. warrants this product, to the original consumer purchaser, to be free from
defects in material and workmanship for a period of one (1) year from the date of purchase.
Maxxsonics USA Inc. will, at it’s discretion, repair or replace defective products during the warranty
period. Components that prove to be defective in materials and workmanship under proper installation
and use must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was
purchased. A photocopy of the original receipt must accompany the product being returned. The
costs associated with removal, re-installation and freight are not the responsibility of Maxxsonics
USA Inc. This warranty is limited to defective parts and specifically excludes any incidental or
consequential damages connected therewith. To view the full warranty, please visit the website.
The information contained within this document is intended to offer some basic guidelines
for a few of the most common installations. More complex audio systems should be
installed by a competent professional. Additional installation information available at
www.maxxsonics.com
Hifonics products are designed and engineered in the USA by
847-540-7700
www.maxxsonics.com
9V
0.2V
INPUT
LEVEL
6V
0.2V
INPUT
LEVEL
PHASE
0
180
BASS EQ
0
10dB
BASS EQ
0
9dB
15
35Hz
SUBSONIC
10
40Hz
SUBSONIC
30
250Hz
LPF
35
250Hz
LPF
40
300Hz
LPF
FULL
LP
HP
XOVER
MONO STEREO
MODE
FULL LPF HPF
XOVER
MONO STEREO
MODE
4CH
2CH
MODE
60
1.3KHz
HPF
60
1.2KHz
HPF
9V
0.2V
INPUT
LEVEL
6V
0.2V
INPUT
LEVEL
PHASE
0
180
BASS EQ
0
10dB
BASS EQ
0
9dB
15
35Hz
SUBSONIC
10
40Hz
SUBSONIC
30
250Hz
LPF
35
250Hz
LPF
40
300Hz
LPF
FULL
LP
HP
XOVER
MONO STEREO
MODE
FULL LPF HPF
XOVER
MONO STEREO
MODE
4CH
2CH
MODE
60
1.3KHz
HPF
60
1.2KHz
HPF
9V
0.2V
INPUT
LEVEL
6V
0.2V
INPUT
LEVEL
PHASE
0
180
BASS EQ
0
10dB
BASS EQ
0
9dB
15
35Hz
SUBSONIC
10
40Hz
SUBSONIC
30
250Hz
LPF
35
250Hz
LPF
40
300Hz
LPF
FULL
LP
HP
XOVER
MONO STEREO
MODE
FULL LPF HPF
XOVER
MONO STEREO
MODE
4CH
2CH
MODE
60
1.3KHz
HPF
60
1.2KHz
HPF
9V
0.2V
INPUT
LEVEL
6V
0.2V
INPUT
LEVEL
PHASE
0
180
BASS EQ
0
10dB
BASS EQ
0
9dB
15
35Hz
SUBSONIC
10
40Hz
SUBSONIC
30
250Hz
LPF
35
250Hz
LPF
40
300Hz
LPF
FULL
LP
HP
XOVER
MONO STEREO
MODE
FULL LPF HPF
XOVER
MONO STEREO
MODE
4CH
2CH
MODE
60
1.3KHz
HPF
60
1.2KHz
HPF
9V
0.2V
INPUT
LEVEL
6V
0.2V
INPUT
LEVEL
PHASE
0
180
BASS EQ
0
10dB
BASS EQ
0
9dB
15
35Hz
SUBSONIC
10
40Hz
SUBSONIC
30
250Hz
LPF
35
250Hz
LPF
40
300Hz
LPF
FULL
LP
HP
XOVER
MONO STEREO
MODE
FULL LPF HPF
XOVER
MONO STEREO
MODE
4CH
2CH
MODE
60
1.3KHz
HPF
60
1.2KHz
HPF
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
CH 1
CH 2
BRIDGED
CH 3
CH 4
BRIDGED
OUTPUT
SPEAKER
OUTPUT
CH 3
CH 4
BRIDGED
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
CH 1
CH 2
BRIDGED
CH 3
CH 4
BRIDGED
OUTPUT
SPEAKER
OUTPUT
CH 3
CH 4
BRIDGED
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
CH 1
CH 2
BRIDGED
CH 3
CH 4
BRIDGED
OUTPUT
SPEAKER
OUTPUT
CH 3
CH 4
BRIDGED
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
CH 1
CH 2
BRIDGED
CH 3
CH 4
BRIDGED
OUTPUT
SPEAKER
OUTPUT
CH 3
CH 4
BRIDGED
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
CH 1
CH 2
BRIDGED
CH 3
CH 4
BRIDGED
OUTPUT
SPEAKER
OUTPUT
CH 3
CH 4
BRIDGED
SPEAKER
OUTPUT
SPEAKER
LEFT
RIGHT
BRIDGED
OUTPUT
SPEAKER
OUTPUT
SPEAKER
OUTPUT
Congratulations on your choice of a Hifonics amplifier.
This “Quick Start Installation” guide is meant to help you
“hook up” and play music. For more detailed information,
on system setting, speaker and subwoofer configuration
and full specifications by model visit the website,
http://hifonics.com/manuals.html
HF BE35 2015 QSG 01 - rev1
6V
0.2V
LEVEL
BASS EQ
0
12dB
30
250Hz
LPF
60
1.2KHz
HPF
CHANNEL 1/2
6V
0.2V
LEVEL
BASS EQ
0
12dB
30
250Hz
LPF
60
1.2KHz
HPF
CHANNEL 3/4
FULL
LPF
HPF
X-OVER
FULL
LPF
HPF
X-OVER
2CH
4CH
3CH
MODE
6V
0.2V
LEVEL
BASS EQ
0
12dB
30
250Hz
LPF
60
1.2KHz
HPF
CHANNEL 1/2
6V
0.2V
LEVEL
BASS EQ
0
12dB
30
250Hz
LPF
60
1.2KHz
HPF
CHANNEL 3/4
FULL
LPF
HPF
X-OVER
FULL
LPF
HPF
X-OVER
2CH
4CH
3CH
MODE
FULL LPF HPF
XOVER
MONO STEREO
MODE
40
300Hz
LPF
10
40Hz
SUBSONIC
BE35 500.4
BE35 800.4
BE35 1200.1D
BE35 2100.1D
BE35 2500.1D
BE35 5000.5
40Hz 300Hz
LOW
PASS
15Hz
35Hz
SUB
SONIC
35Hz2 50Hz
LOW
PASS
BE35 1700.1D
CH 3/
4
HPF
HPF
CH 1/
2
CH 3/
4
10Hz1
.5KHz
HPF
10Hz1
.5KHz
10Hz1
.5KHz
CH 3/
4
FULL LPFH PF
XOVER
HPF
LPF
FULL LPFH PF
XOVER
HPF
LPF
CH 1/
2
CH 3/
4
FULL LPFH PF
XOVER
HPF
60Hz1
.2KHz
30Hz
1.5Hz
60Hz1
.2KHz
30Hz
1.5Hz
60Hz1
.2KHz
30Hz
1.5Hz
LPF
30Hz 1.5Hz
LPF
40Hz 300Hz
LPF
