18
16
2-Channel-Mode Stereo Front- or Rearsystem
RCA & Speaker wiring:
• Connect the LINE INPUT of the amplifier to the head unit line output with appropriate good quality RCA cables.
• Connect the speakers with appropriate wires to the terminal block (SPEAKER OUTPUT/ - CH1 + and - CH2 +) of the amplifier.
• The minimum final speaker impedance must not be lower than 2 Ohms per channel. Too low speaker loads result in too high
heat dissipation and may cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal
Caution!
Do not connect speaker (-) to the ground or vehicle's chassis.
X-Over Switch
• By using bigger speaker systems (
Ø
20cm), set the switch on FULL-position (FULL RANGE Signal).
• By using smaller speaker systems (
Ø
8.7cm -
Ø
16cm), set the switch on HP-position (HIGH PASS Signal).
The cut-off frequency should be between 60Hz - 150Hz. Adjust the level by the LO PASS-contoller.
• In this configuration the LOW PASS - Mode is out of function.
Input Level
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80 - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
Bass EQ
• This controller should be set to 0dB-position.
Bass Remote
• The provided Bass Remote is not required in this configuration.
Speaker & RCA Connections
ZXi 4000 / ZXi 6000 / ZXi 9000
Connect RCA cable (CH1/2) from head-unit with
RCA input (CH1/2 L/R LINE INPUT).
Left Speaker
2 - 8 Ohm
Right Speaker
2 - 8 Ohm
ZXi 4000
MkII
2 x 200 Watts
e13
021581
FUSE
GND
REM BATT+ 12V
POWER INPUT
SPEAKER OUTPUT
+ CH1 –
+ CH2 –
+
–
MONO BRIDGED
