Insert screws through Wall Mount Brackets (G) and into
Wall
and
Base Board at a downward angle.
8-3" (76.2mm) Flat Head Screw (8pcs)
Attach the Wall Mount Brackets (G) to the Floor
Yokes (H) using the Bolts, Nuts and
Washers shown below. Place bolt heads on outside.
Do not tighten bolts now so you can adjust later.
M8x20mm Bolt, 2 Flat Washers, Nylock Nut (4 sets)
Attach the Bottom Spring Tube (J) to the Floor Yokes (H).
M8x20mm Bolt (4pcs)
1
J
H
H
H
G
Section 2: YOKE ASSEMBLY
Assemble the Yoke Assembly components as shown. If you are installing the bed in a 16” deep cabinet,
fasten the Floor Yokes and Wall Mount Brackets together not to exceed a 15” projection from the base
board or wall. Secure the Yoke Assembly to the base or wall with the screws provided while following the
steps below.
Match fasteners with the actual-size drawings to ensure you use the correct pieces.
Attach Yoke Connector Bar (I) to the
Floor Yokes (H).
M6x18mm Bolt, Nylock Nut (2 sets)
4.
2.
1.
3.
2.
I
3
H
4
4
G
2
2
H
G
G
Updated
130717
MWBS
