Stand the Bed Face Panel on the Head end and align it just in front of the Tension
arms. Gently (do not bump the Torsion Arms) work the Side Rails into position
between the Torsion Arms. Carefully lift the Bed Face Panel approximately 4”
(100mm) or enough for the 5/16” (8mm) bolt loosely secured in hole #3 to drop into
the slot on the end of the Tension Arm. Repeat this procedure on both sides of the
Bed Face Panel.
Tilt the Bed Face Panel out until the arm locks disengage and the Allen socket head
bolt head, in hole #1, is seated in the notch at the bottom of the tension arm. Tighten
the 5/16” (8mm) bolts in holes #3 securely.
Install the 5/16” (8mm) bolts in holes #2 and securely tighten. Let the Bed Face Panel
close gently. Do not let it slam shut. Damage can be caused by slamming - especially
if the mattress is not in place.
ALERT:
Place the mattress across the Bed Face Panel so it will not slam shut. If this
is not possible, your assistant must hold the panel down.
6.
7.
8.
9.
STEP 7: Install the Bed Face Panel in Cabinet (cont.)
Allen Bolt in
Hole #1
Bolt Hole #2
Head of Bolt
in Hole #3
Bed Panel
Face
Allen Bolt in
Hole #1 seated
in notch
Bolt Hole #2
Bolt Hole #3
seated in slot
Bed Panel
Unit Rail
Side Panel
Side Panel
Drawing 14.
Drawing 15.
18.
