Using a studfinder,
locate three wall
studs to be at-
tached to (one near
the center of the bed, and
one on each side). Draw a
vertical pencil line that will
appear above and below
the top assembly. Move the
Hiddenbed to the desired
location and lift and lock the
bed in the up position.
(CAUTION-The unit is un-
stable and may try to fall
over. DO NOT leave unat-
tended in this position!)
Push some folded card-
board between the cabinet
sides and bed tray on each
side to assure even spac-
ing. Mark the wall at each
upper corner of the cabinet,
then cautiously unlock and
lower the bed. Attach to the
wall studs by driving 2 1/2”
screws through the top as-
sembly backrail, close to
the top, at the stud points
marked for alignment.
YOU MUST HIT STUDS,
as sheetrock or paneling
will not hold the bed up!
15
CONNECTING THE LEVER ARM
Raise and LOCK the bed in the up position. Hold the
desk wing and pull the lever arm down to the bearer,
then release to connect gently with the bearer. Verify that
the desk is sitting fully up to the side panel. If it is not,
slightly loosen the bearer bolts allowing it to do so, then
retighten securely. Then apply screws to each of the
three flange holes of the bearer fittings on each end of
the desk. One lever arm at a time may be released for
screw access.
MOUNT TO THE WALL
16
INSERT MATTRESS-
Strap and buckle your
mattress (10” thick or
less) into the tray and
tuck the excess strap-
ping under one side.
17