pivCLASS How to Order Guide – D00456, A.4
Page 10 of 11
© 2007-2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
May 2013
Reader Programming Cards
Reader programming cards are used to reconfigure a reader to a desired target configuration by using Reader Configuration Cards. Firmware Update Cards can be
used to reload the reader with the latest version of firmware. Contact HID Technical Support (
) to ensure selecting the proper configuration
card extension.
Reader Configuration Cards
Description
Part Number
Base Part No.
iCLASS Security Keys
Configuration Card Extension
Reader Mode and Output Configuration Settings
Use these part numbers to order configuration cards to change reader modes (e.g.,
Wiegand to PAM) and output formats (e.g., 200 bit Wiegand).
Includes reader configuration programming card and instructions
SEC9X-CRD-
0 = Standard
E = Elite
-XXXX = Specific configuration
1
Reset Beeper / LED, Keypad and IPM to Factory Defaults
Use these part numbers to order configuration cards to reset reader settings to factory
defaults.
Includes reader configuration programming card and instructions
SEC9X-CRD-
0 = Standard
E = Elite
-0000 = Factory configuration (Rx models)
2
-0001 = Factory configuration (RPx models)
-0002 = Factory configuration (RKx models)
-0003 = Factory configuration (RPKx models)
1
Contact your HID Global Support representative (
) to determine your specific configuration extension.
2
Factory Default configurations include: LED normally red, beep on and flashes green on read card; keypad data = buffer one key, no parity, 4 bit message, Intelligent Power Management = Off; Prox reads 125 kHz HID Prox,
AWID, Indala (ASP10022), EM4102.
Firmware Update Cards
For updating reader interpreters and other functionality to the latest firmware version over an RF interface.
Description
Part Number
Programming Cards – Firmware
Base Part No.
iCLASS
Security Keys
Version
Update Card Extension
Firmware Update Cards
Includes latest version of reader firmware on a RF programming card and instructions.
SEF9X-UPG-
0 = Standard
E = Elite
E = Rev E Version
-XXXX
1
1
Contact your HID Support Representative (
) to obtain the Firmware Update Card extension.
