8
OPERATING INSTRUCTIONS
7
There should be a fine mist coming from your
saw blade while it spins. If there isn’t, pour
additional water over the blade until there is a
mist.
Note: In use, always make sure the saw blade
is properly lubricated. Never run dry.
8
After each use, turn off the machine, then
unplug your slab saw from its power source.
Drain the water reservoir be removing the drain
plug. Dry the machine and saw blade with paper
towels or a cloth. You may also spin dry the saw
blade by running it on the slab saw until it is
completely dry.
Notes: Always dry your saw blade
after each use to prevent rusting. Keep out of reach
of children.
4
Replace the saw table. Insert the black spray
shield (part #8) into the two slots located at
the front of the saw table (Fig. C). The spray shield
can be inserted in either direction.
5
Before turning your slab saw on, manually
spin the saw blade towards you to make sure
the blade is not in contact with the saw table.
If there is contact, see page 11 for instructions
on how to position the saw blade for clearance.
Note: Some saw blades tend to wave side to side as
you spin them. They typically straighten out after
turning the machine on.
6
Put on safety goggles (not included), then
turn on the machine by turning the power
switch to the on position.
Note: Cutting speed
depends on the type of saw blade you are using.
Never exceed the saw blade’s maximum rpm.
Fig. C
