Hi-Flame Graphite GR357i, Инструкция по эксплуатации

Страница: 23 / 24

FIRST SERVICE
Work carried out:
SECOND SERVICE
Work carried out:
THIRD SERVICE
Work carried out:
FOURTH SERVICE
Work carried out:
FIFTH SERVICE
Work carried out:
Next Service Due
Signed Print
Dealer’s Stamp or HETAS Registration Number
Next Service Due
Signed Print
Dealer’s Stamp or HETAS Registration Number
Next Service Due
Signed Print
Dealer’s Stamp or HETAS Registration Number
Next Service Due
Signed Print
Dealer’s Stamp or HETAS Registration Number
Next Service Due
Signed Print
Dealer’s Stamp or HETAS Registration Number
Date
Date
Date
Date
Date
ANNUAL SERVICE
In the interests of safety it is important that your
Graphite stove is serviced on an annual basis in
accordance with the instructions outlined below. This
should be carried out by a suitably qualified person
such as your original approved installer, a Hetas or
INFO registered installer or your authorised Graphite
dealer.
When the stove is cold strip, clean and inspect it.
Internal Components
Remove and inspect the
following: Baffle Plate, Firebricks, Grate Assembly
and Ash Pan.
Use a wire brush to clean the baffle plate and grate
assembly and firebricks. Wire brush the inside of the
stove and remove all ash and debris from inside the
stove and the ash pan chamber.
Check all parts for wear or damage and replace as
necessary. Re-fit all the internal parts.
Stove Glass
Check the glass for chips or cracks and
the glass seal condition and replace if necessary.
Thoroughly clean the stove glass on both sides.
Door Seal Check that this makes an air-tight seal and
replace if necessary. Ensure that the new rope joint is
also in the middle at the base of the rope seal channel
External Bodywork All external surfaces should be
dusted with a soft cloth or light brush.
• Examine all paintwork for signs of wear and re-paint
these areas using an appropriate heat-resistant black
aerosol paint.
Warning: do not use the aerosol if the
stove is alight or hot.
• When the aerosol paint has dried, apply traditional
stove black polish to all painted surfaces
• Lightly oil the hinges and locking mechanism
Air Controls When standing down at the end of
the heating season these should be left in the open
position to allow some movement of air which will
help avoid condensation and moisture building up
inside the stove and flue system. These can be closed
up to 50% if it gets too draughty.
Liner Connection
If a chimney liner has been
installed check that the liner is secure and that the
cement seal is good. Repair crumbling or failed seals
by using the appropriate heat-resistant fire cement.
Important In the interests of safety use only genuine
Graphite replacement parts which are readily available
from your authorised dealer.
NB It is advisable to have the chimney or flue system
swept at the same time.
23