HH Tensor TRE-112A, Руководство пользователя

Страница: 9 / 19

The HH range of active PA systems utilise our highly efficient and musical Biamp module,
featuring a 500W RMS Class D amplifier for low and mid frequencies, with a 50W RMS
Class A/B amplifier reproducing the high frequencies. Both amps are driven by a lightweight
switch mode power supply, with an active crossover ensuring superb detail and clarity
through the British designed HH drivers. Simple but effective controls allow intuitive
adjustment of the powerful amplifier stages.
All models feature high performance HH woofers, utilising Kevlar and glass fibre reinforced
cones, high temperature ribbon wire coils and powerful motor structures for responsive,
detailed sound. In Tensor models these are combined with 1” exit / 1.75” titanium
diaphragm compression drivers in precision moulded polymer cabinets. The Tessen series
feature 1.4” exit / 2” titanium diaphragm compression drivers mounted in robust plywood
cabinets. All models feature an EQ preshape switch and a balanced link output to connect
to other active cabs. All are fitted with 35mm pole mounting sockets (except TNE-212A).
This manual contains important information regarding correct and safe operation of your
active PA system. Please read it thoroughly in order to get the best performance and
reliability from your HH product.
Unpacking
Inspect the product during unpacking, if any damage is found, notify the dealer you
purchased it from immediately. Be sure to save the carton and all packaging materials.
Should you ever need to return the unit back to the dealer or HH Electronics, use only the
original factory packing.
Basic Setup
HH Active PA cabs can be mounted on the floor, a suitable pole or tripod (except TNE-
212), or stacked. PA stacks should always be secured by suitable strapping. Connect a
suitable mains lead to the mains inlet on the rear panel, and a line level signal to the input.
Set the level control to minimum before switching on.
Switching Off
After using the amplifier, please adjust the gain controls to their lowest settings, then the
amplifier can be turned off safely. Turn the power switch to the OFF position and remove
the power cord from the electrical source.
NOTE:
Do not connect or disconnect from the input signal source when the amplifier is turned
ON, damage could occur to the amplifier and the speaker.
When the amplifier is connected to the power supply, power is present inside, even in
standby mode where the power switch is in the OFF position.
If the amplifier is in standby mode without use for over 3 hours, remove the power cord
from the electrical source.
INTRODUCTION