HH Electronics Vector VRC-210, Руководство пользователя

Страница: 10 / 29

Designed and Engineered in the UK by HH Electronics LTD. © 2019 HH Electronics Ltd
10
(Stand not included)
35mm pole socket
HINTS AND TIPS
BASIC SETUP
SWITCHING OFF
Ÿ Use the minimum cut or boost in EQ. If all bands are boosted or cut, flatten
EQ, re-adjust gain and start again.
HH VRE cabs can be mounted on the floor, or a suitable pole or tripod. Don't
over-extend poles/tripods; ensure at least 4 x the pole diameter is still inside the
outer pole. Make sure the legs have a good splay on tripods, but do not obstruct
doorways or other access-ways.
Inspect the product during unpacking, if any damage is found, notify the dealer you
purchased it from immediately. Be sure to save the carton and all packaging materials.
Should you ever need to return the unit back to the dealer use only the original factory
packing. Pack all cables neatly, use cable ties to tidy excess cable length in 'figure-8' not
loops.
Do not connect or disconnect from the input signal source when the amplifier is
turned ON, damage could occur to the amplifier and the speaker.
If a pole mount is used, make sure that the thumb screw on the cabinet is tight.
After using the amplifier, please adjust the gain controls to their lowest settings,
then the amplifier can be turned off safely. Turn the power switch to the OFF
position and remove the power cord from the electrical source.
NOTE:
QUICK TIPS
UNPACKING
Ÿ
Use electronic safety devices such as circuit breakers.
Ÿ
Start with EQ settings flat and gains low.
Ÿ Master volumes should be at zero for switch on and off.
Ÿ Use input gain to set maximum signal level without distortion.
Ÿ Avoid damp environments and extremes of temperature for storage and use of
all audio equipment.
Ÿ
Look after your cables. Do not stand equipment on, or run cases over them,
do not tie knots in them and always use them for the correct application (a
signal lead is NOT a speaker lead). Coil and secure with cable ties before
storing.
Ÿ Keep lights away from speakers; heat can cause fires/speaker damage.
Ÿ Be aware of total power usage. Overloading a mains socket is potentially dangerous,
and likely to cause a power out during use.
Ÿ
Keep power and signal cables apart.
Ÿ
Don't run cables across access-ways; if you have to, run them above doors or use
approved cable covers.
Ÿ Set up mic levels first, and adjust other equipment to match.
Ÿ
Avoid very high onstage levels from backline amps.
Ÿ
Ensure your equipment is properly loaded and cannot move around during
transit .
10