1. PowerNAS - Quick Start
PowerNAS is configured
ready to work
right out of the box:
•
Unpack PowerNAS:
consider where PowerNAS will be placed. Being a passive
cooled system (no fans) ideally do not place PowerNAS in an enclosed cabinet, in
direct sunlight and never near sources of water. Ensure the vents on the top are left
uncovered, it is normal for the sides of PowerNAS to get warm to the touch when
PowerNAS is working hard.
•
Connecting PowerNAS to your Network:
PowerNAS requires a wired connection to
your wireless or broadband router, Gigabit LAN preferred.
•
Plug PowerNAS into the mains:
connect the mains power ‘brick’ to PowerNAS
before switching on at the mains. PowerNAS only requires a mains & network
connection, no keyboard, mouse or screen required. Tap the PowerNAS
On / Off
switch at the front lower right side to power on,
•
Check PowerNAS is operating:
after switching on the blue power light should
illuminate on the front, occasionally the hard drive activity light will flash, also the
network lights on the back (yellow) should illuminate to show a good Ethernet
connection. PowerNAS takes approximately 60 seconds to startup.
Should you wish to switch off PowerNAS, tap the
On / Off
button and wait for the power
lights to extinguish. PowerNAS is designed as a server for 24 / 7 operation with low power
usage.
Warnings:
•
Do not cover the venting holes
•
Do not touch when running hot (heatsinks can get up to 60°C)
•
Do not open the PowerNAS, this might lead to a loss of warrenty
V1.2
[2]
Содержание PowerNAS 2011
Страница 3: ...V1 2 3...
