PAGE 9
STaTUS IcoNS
When necessary, the following four status icons will be displayed
on the right hand side of the display.
Display units
This will be either ‘PPM’ or ‘%’ for oxygen concentration values.
Press and hold ‘display’ button to change the display units.
Battery status
When the PurgEye
®
200 IP65 is running on batteries a filled
battery icon will be displayed. A low battery warning is indicated
by an empty battery icon .
When an external power supply is connected and the battery is
charging, the battery symbol will animate from empty to full. A mains
plug icon
will be displayed when the battery is fully charged.
Pump status
When the sample pump is enabled, you will see an arrow icon
scrolling to the right, if the PurgEye
®
has detected that there is
insufficient flow for an accurate reading then this icon will flash to
indicate a possible inaccurate reading.
NoTE: Insufficient flow could be due to a blocked filter or very long
sample pipes. Filters must always be used and should be replaced
on a regular basis. The PurgEye
®
1000 Weld Purge Monitor
®
should
be considered, if you are having problems with long lengths of purge
gas sample tubes.
Alarm status
Whilst the alarm is active, a speaker icon will flash on the
display. If the mute function is activated then the speaker icon will
show a cross
beside it.
