1. Keep this product and its charging cable away from excessive heat.
2. Do not operate this device with a damaged cable or after it has malfunctioned or has been damaged in any manner.
3. Do not disassemble your device.
Charging Your Speaker
1. Connect one end of the included USB Charging Cable to the Charging Port on your speaker. Then plug the other
end of the USB Charging Cable into a suitable USB port on your computer to recharge your speakers internal
rechargeable battery.
NOTE:
The internal battery of your speaker takes approximately Three hours to charge when completely drained.
2. When charging, a red LED light will illuminate to indicate that the unit is charging. The red light will turn off when
your unit is fully charged.
Tips
:There will be a beep when the battery is low and needs to be recharged. To protect the the battery's durability,
fully
the speaker if it is not used for a long time
A Quick Look At Your Device
1.
Previous
: Press and hold to access the last track in playlist.Press to lower the volume.
2.
Next:
Press and hold to access the next track in playlist.Press to increase the volume.
3. ON/OFF Switch (Play/Pawse)
Press and hold the
“
”
for power on
Press and hold the
“
”
again for power off
Press this button to activate the speaker phone function.
When music is playing, press to play or pause a track.
4. Light Change
Short press this button to cycle through 5 light modes.
Under the playing music mode, you can press and hold the light button to enter the light flash with music mode.
5. Chaining Port/Aux-in
You can plug one end of the included USB Charging Cable into this jack, while plugging the other end into a USB
port on your computer in order to charge your speaker's built in lithium battery.
Understanding The LED Status Lights
When Charging Your Speaker
Solid red LED = Charging
No red LED = Charge Complete
When Pairing Your Speaker To A Bluetooth Audio Source
Rapid blinking blue LED: Bluetooth not connected. (Ready to pair.)
Solid blue LED: Bluetooth connected.
Aux-In Mode
1.Power on,the Blue LED stay illuminated.
2.Plug in the supplied 3.5mm cable into the unit. The other end is connected to your device.
3.The blue LED will blink slowly to indicated that you have entered Aux-In mode.
Pairing Bluetooth Devices To Your Speaker
charge