Hexagon VERIPOS LD900, Инструкция по установке и эксплуатации

Страница: 47 / 86

Configuration and Operations
LD900 Installation and Oper ations M anual 47
If selecting NMEA , a choice of GGA , GLL , VTG , ZDA , GST , GSA , GSV , GRS and RMC will be shown, followed
by a request to pick an NMEA output rate of 1 (default), 2 , 5 , 10 or 20 Hz. If heading is licensed and enabled
HDT will also be shown and additionally if INS is licensed PASHR will be shown.
Once configured the user will be returned to the
Configuration > Ports page.
4.6.4.3 Configuration > Ports > P (1 to 7)
If the single format rack mount system is interfaced seven Moxa serial port expansion unit ports and will be
available. These will be named P1 - P7:
To select a specific port for input or output use the arrow buttons and tick to select the required
P# port. A P#
Settings page will then be displayed. With Baud Rate highlighted use tick to Edit the baud rate if required.
LD900 P1-7 are set to a baud rate of 115200 by default but support a baud rate between 1200 to 460800. Use
the Arrow keys followed by tick to select the required baud rate.
Once returned to the P# Settings page, use the arrow buttons to highlight Additional Settings and tick to Edit .
Use the up and down arrow buttons to navigate through the options and tick to Edit as required:
P Port Moxa Port
P1 1
P2 2
P3 3
P4 4
P5 5
P6 6
P7 7