Hewlett Packard Enterprise ProLiant ML350 Gen10, Руководство пользователя, Страница: 10 / 214

Item Description Status Definition
1 UID button/LED
1
Solid blue Activated
Flashing blue • 1 flash per sec = Remote management or firmware
upgrade in progress
• 4 flashes per sec = iLO manual reboot sequence
initiated
• 8 flashes per sec = iLO manual reboot sequence in
progress
Off Deactivated
2 NIC status LED
1
Solid green Linked to network
Flashing green Network active
Off No network activity
3 Health LED
1
Solid green Normal
Flashing green iLO is rebooting
Flashing amber System degraded
2
Flashing red System critical
2
4 Power On/Standby
button and system
power LED
1
Solid green System on
Flashing green Performing power-on sequence
Solid amber System in standby
Off No power present
3
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see Front panel LED
power fault codes.
2
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
3
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the front
I/O cable is disconnected.
Server UID LED
The UID LED is used to locate a particular server when it is deployed in a dense rack with other equipment. Activating the
UID LED helps an onsite technician to quickly identify a server for maintenance tasks.
Toggling the UID LED on and off locally
Procedure
1. Remove the front bezel.
2. Do one of the following:
10
Component identification