Hewlett Packard Enterprise aruba, Руководство по устранению неисправностей, Страница: 24 / 41

Instant APs Managed by AirWave | 24
The AP must be manually authenticated and assigned to a Device group in the Devices > New page in
AirWave. Ensure that shared key entered on the AP and the shared key of the AP group are the same. If the
shared key of the AP group and the AP are different, the AP will remain unprovisioned.
Check the Authentication Settings for Instant APs in AirWave
Ensure that AirWave is configured with the appropriate authentication method. The authentication settings
of AirWave are available in the
AMP Setup > General page under Aruba Instant Options .
AP Fails to Receive Configurations From AirWave
The following procedure describes how to troubleshoot issues, if the AP fails to receive configurations from
AirWave:
1. Check AirWave Operation Mode
2. Check the Configurations Received from AirWave
Check AirWave Operation Mode
Ensure that AirWave management mode for the AP is Manage Read/Write .
Run the show ap debug airwave command in the CLI of the AP to view details of AirWave server. Check
the Mode column to identify the management mode of AirWave.
The sample below displays details of the AirWave server, generated by the show ap debug airwave
command:
Airwave Server List
-------------------
Domain/IP Address Type
Mode
Config-only Rapids-mode Status
----------------- ---- ---- ----------- ----------- ------
1.1.1.1 Primary
Manage
- No Not connected
----------------- ---- ---- ----------- ----------- ------
The AP cannot receive configurations from AirWave if the management mode is set to Monitor-
only+Firmware Upgrades . The following procedure describes how to change the management mode of
AirWave:
1. Navigate to the Devices > List page in the AirWave UI.
2. Right-click on the device and select Manage to open the Manage page.
3. Under General , select Manage Read/Write.
4. Click Save & Apply .
Check the Configurations Received from AirWave
Run the show ap debug airwave-config-received command in the CLI of the AP to view configurations
received from AirWave. Verify if the output includes the latest configurations made in AirWave.
The sample below displays the configurations received by the AP from AirWave, generated by the show ap
debug airwave-config-received command:
(Instant AP) show ap debug airwave-config-received
wlan access-rule "IHG_App001": OK
rule any any match app yahoo permit log: OK
rule any any match app yahoo-answers permit log: OK
rule any any match app yahoo-buy permit log: OK
rule any any match any any any permit: OK
exit: OK
wlan ssid-profile "IHG_App001": OK