7
Receiver Housing
The receiver wiring is critical for proper system
operation. Make all connections with good quality
contacts or solder joints to ensure proper electrical
contact.
Supply voltage and ground wiring are crucial and must
be connected to reliable connecting circuitry. Do not
use a chassis ground for this equipment. The ground
wire must be connected directly to the crane/machine’s
ground.
The output control signals to proportional controls
should be routed separately from any wiring that could
produce transient voltage interference. Interference or
"induced voltage spikes" could cause erratic
performance of the controls.
EXTERNAL ANTENNA INSTALLATION
If the receiver is to be mounted inside a control panel
or other enclosure, an external antenna will be
required. It can also be used where a standard antenna
is difficult to mount. For the best reception, the antenna
should point upward.
NOTE:
Improper installation of the antenna can cause
intermittent signal loss.
Standard Antenna Extension
1. Unscrew the antenna from the receiver housing.
2. Connect the antenna to the antenna extension
assembly by the housing block.
3. Connect the other end of the antenna cable to the
antenna base on the receiver housing.
4. Insert the mounting screws through the holes in
the housing block and tighten into the mounting
surface.
5. Bundle any excess antenna cable and secure
with tie wraps or equivalent.
IMPORTANT:
DO NOT run the antenna cable with
power or control wiring. Intermittent signal loss will
result.
Top Mount Antenna Extension
1. Prepare the mounting surface by drilling a
26-27mm (1 inch) hole to fit the antenna bracket.
2. Position the antenna connector assembly through
the hole with the connector facing up.
3. Install and secure the antenna and seal assembly
onto the mounting surface with parts provided.
4. Unscrew the antenna from the receiver and
connect it onto the mounted antenna extension.
5. Connect the other end of the antenna cable to the
antenna base on the receiver housing.
6. Bundle any excess antenna cable and secure
with tie wraps or equivalent.
+12 / 24VDC
GND (-)
PWM1
PWM2
K3
K4
K5
K6
K7
K8
K9
K10
MC
K11
K12
K13
K14
UB2
K1
K2
K15
K16
IN1
IN2
B7
B6
B4
B5
B3
A6
A7
A5
A8
A4
A9
A3
A10
A2
A11
A1
A12
B10
B12
B1
B11
B2
B9
B8
(A)
118 mm
(4.6 in)
102 mm
(4.0 in)
133 mm
(5.2 in)
88
22
99
33
1100
44
1111
55
1122
66
11
77
22
88
33
99
44
1100
55
1111
66
1122
77
11
36 mm
(1.4 in)
210 mm
(8.2 in)
RX-MFSHL DC16-PWM
Antenna Extension
Cable Assembly
Connect the
Antenna here
Housing
block
P/N 56501315
Top View
Install the
Antenna here
Connect
to receiver
Bottom View
P/N 56501415
PRELIMINAR
Y COPY
