13
Assembly, Operation & Maintenance Instructions
STEP 01
/ Take the Ø4mm spring washers (F03) and Ø0.2in (4mm) washers (F04) and place them
onto two M4x0.4in (10mm) screws (F01). Take the two lid hanging brackets (04) and fit
onto the two M4x0.4in (10mm) screws (the legs of the brackets should hang around the
screw heads). Place the handle (02) on the inset side of the lid (03) and align the handle
legs with the two holes. Fix the lid hanging brackets to the bottom of the lid by screwing
the screws into the handle legs (take care that the hanging brackets are running parallel
to the lid shorter sides). Tighten fully. If assembled correctly, the lid will hang from the
bracket at the rear of the barbeque using the lid hanging brackets to hook it in place.
STEP 02
/ Rotate the barbeque chassis assembly (01) onto its rear panel and lay on a clean flat
surface (the cardboard packaging is ideal). Fix the four legs (14, 15, 16 & 17) to the
bottom panel (castors to the left hand side) using sixteen M6 bolts (F02). Note that
when finished, the legs will angle out towards the corners.
STEP 03
/ Take the two Top Panel Covers (05) and place them over the end of the rotisserie poles
at either end of the barbeque. Press into place.
