HES HS7003A-BA, Руководство пользователя, Страница: 10 / 29

3-4 INSTALLATION OF ROLLER COATER
Place the roller coater on the flat and proper position that near
production line, and make sure the control panel is easy to operate.
There must be enough space for operators to work.
1) Place the machine on a flat surface, and fix the machine by four
screws fixed on the double edge of machine.
2) Do not install the machine where the ambient temperature is below
0 or above 50 .
℃ ℃
3) If this roller coater is installed outside factory or the
well-ventilated area, please try to avoid the HMA being touched
by ventilation air, due to the coating will be influenced.
4) This roller coater is not a fully hermetic and water-proof
equipment, please do not spray water near machine. It will cause
machine get short, damaged and eroded by these water.
3-5 INSTALLATION OF POWER SUPPLY
The power rate of this roller coater is 220VAC and single phase,
please note the following items while installation.
1) Do not attempt to amend the roller coater to work at other voltage.
Otherwise the roller coater will get damaged.
2) Make sure the external power supply is disconnected before
checking electrical components.
NOTE:
After finishing the above steps, please do not turn on the power immediately.
Kindly read the next chapter and then turn on the power.