IMPORTANT SAFETY PRECAUTIONS
READ THESE INSTRUCTIONS CAREFULLY AND RETAIN FOR FUTURE REFERENCE.
Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1.
This appliance must be disconnected from its power source during installation or service activities and when
replacing.
2.
The INSPIRE is not equipped with an integrated device to control the room temperature. If intended for use
in an enclosed space for the purposes of room heating,
Herschel iQ controls
must be used
. If you do not fit
a room temperature controller,
DO NOT
use for room heating when rooms are occupied by people
incapable of leaving the room on their own, unless constant supervision is provided. Herschel is not
responsible for any breach of EcoDesign or Safety legislation where the heaters are used in an enclosed
space without use of a Herschel iQ controller.
3.
In order to avoid overheating and potential fire hazard,
DO NOT
cover the heater with insulating material
or similar material under any circumstances.
DO NOT
locate the heater within 0.3m of any flammable
materials (eg. Furniture, curtains).
4.
DO NOT
touch the heater when in use. Herschel panel heaters have a surface temperature of around 95°C
/ 248°F and prolonged contact with the heater will cause burns and injury.
5.
DO NOT
operate the heater if the cord or plug is damaged or after the heater malfunctions, or if it has
been dropped or damaged in any manner. Check each heater for damage before installation. Make sure
that the heater itself, the plug and the cable are free of any visible signs of damage. The supply cord cannot
be replaced. If the cord is damaged the appliance must be scrapped in accordance with the local Waste
Electrical Equipment regulations.
6.
GLASS & MIRROR PANEL MODELS. Handle carefully and avoid stressing the glass mechanically. Do not use
the heater if the glass panels are damaged. Disconnect the heater and do not put it into operation again.
Dismount the heater immediately to reduce the danger of direct impact from falling pieces and dispose of
the unit in accordance with the local Waste Electrical Equipment regulations.
7.
This heater must only be used for the heating of people or buildings. The heater is not to be used by children
or persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge.
Children should be kept away and should not be left unsupervised around the unit.
8.
All operators should only switch on/off the appliance provided that it has been placed or installed in its
intended operating position in accordance with these instructions. Children must not plug in, switch on or
regulate the appliance or perform user maintenance including cleaning.
9.
IMPORTANT:
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50 Hz AC.
If your supply voltage exceeds 240 Volts do not use the heater and refer to your local dealer.
10.
IMPORTANT:
The heater must be mounted on a non-flammable surface.
SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION:
Herschel Inspire panels are rated to a standard (minimum IP54) enabling them to be located within zone 2 in a
bathroom. This means they can be placed above a sink or outside any splash zones, or they can be installed on
the ceiling. They cannot be installed in zones 0 or 1.
However, installation in potentially wet or humid rooms such as bathrooms must be carried out by a suitably
qualified installer and comply with local electrical safety requirements. Installation must be such that:
•
the heater must not be able to become detached from the fittings and fall into a bathtub, shower,
swimming pool or other water container;
•
Switches and other controls cannot be touched by a person in the bath or shower.
