USER MANUAL
H-TRACE DYNAMO/E-BIKE
General Information
H-Trace Battery is a modern battery rear light suitable for mounting on a carrier with 50mm mounting
hole spacing. The dynamo version is suitable for both 6V/3W and 6V/1.5W dynamos. The e-bike version
is designed for a DC voltage from 6 to 12V.
Should one of the LEDs fail, the whole rear light unit must be replaced.
Alternative 2: Connect the cable with connector plugs (2.8 x 0.5mm). The contact assignment
(current/ground or +/-) is freely selectable. The rearlight and frontlight must not be switched on
together unless they are operated by the means of a dynamo. In dynamo mode, if the front light
has a switch, the rear light is powered by the front light.
Electrical connection
Alternative 1: Strip the cable ends to a length of approximately 12mm and connect using the
enclosed plastic plugs
Mounting instructions
Alignment: Assemble the rear light so that the reference axis is aligned parallel to the road and the
length axis of the bicycle.
Mounting height: According to German law (§67 StVZO), the rear light must be mounted at a height
of 250-1200mm.
Please note that the unit must not be covered. The light must also be clearly visible from the sides.
Stationary light feature (dynamo version only)
Part of the energy generated by the dynamo is stored in a capacitor which is fully charged in
approximately 3 minutes of cycling. When the bike is stationary, the LEDs are powered by the
capacitor for several minutes.
Reference
axis
90°
Reference axis
90°
