Heroshi Saisho, Руководство по эксплуатации

Страница: 6 / 16

IMPORTANT
Please wash the juicing parts every time immediately after each used, otherwise the pulp might
stick tightly in the Juicing Bowl and on the Squeezing Auger which will then affect the disassembly,
cleaning and juicing performance.
CLEANING AND MAINTENANCE
1. Switch off and unplug the juicer.
2. Wash the disassembled parts (
Fig 10 below ) with water. If the meshes are clogged with pulp,
please use the cleaning brush provided to remove the dregs.
9 8 7 6 1+2 4 3
Attention:
• Do not use an iron wire brush, abrasive or sharp tool to clean the juicer.
• Please do not use water above 40°C.
• Never clean any parts in dishwasher to avoid damage by hot water.
3. In case there is any residue remaining in the mouth of the pulp spout, please pull out the silicone
valve as shown in ( Fig 11 below ) and clean under running water.
Silicone Pull to
valve open
Press the silicone valve to close it properly and tightly after cleaning.
4. To Clean the seal ring in the center of the squeezing bowl, please follow the steps as below:
a. Turn the Squeezing Bowl upside down for easier handling, Push the seal ring out with your
thumb (Fig 12a) and clean it with water.
b. After Cleaning, please put it back to the center hole. The small ribbed surface should be facing
upward (Fig.12b) Make sure the groove of the seal ring fits well in the squeezing bowl.
c. The big flat side of the seal ring will be inside while the small and ribbed side is outside the
Squeezing Bowl. (Fig 12c)
Fig 12a Fig 12b Fig 12c