HEROSE 15C02, Руководство по эксплуатации, Страница: 34 / 108

Operating instructions
herose.com
27
5 Assembly
5.1 Installation position
No restrictions regarding the installation position.
Preferred position: vertical position of the stem (lever/actuator on top)
5.2 Fitting Notice

Use suitable tools.

Allen keys of sizes 6, 8, 10, 14, 19;

Open-ended spanners;

Torque wrench;

TIG welding machine;

Oxy-fuel welding machine;

Clean tools before fitting.

Use suitable transport and lifting equipment for installation.

Open the packaging immediately before installation. Free of oil and grease for oxygen (O
2
)
Valves for oxygen are permanently marked with “O
2
”.
Take note of the HEROSE information sheet “O2 instructions”.

Only install the valve if the maximum working pressure and operating conditions of the plant
correspond to the marking on the valve.

Remove protective caps or covers before mounting.

Inspect the valve for contamination and damage.
DO NOT install a damaged or dirty valve.

Avoid damaging the connections.
The sealing surfaces must remain clean and intact.

Seal the valve with suitable seals.
No sealant (sealing tape, liquid sealing) may enter the valve.
Respect the suitability for use with O
2
.

Connect pipelines in a force-free and torque-free manner.
Stress-free mounting.

To ensure trouble-free operation, impermissible static, thermal or dynamic stresses must not be
transmitted to the valve. Observe reaction forces.

Temperature-dependent changes in length in the pipework system must be compensated with
expansion joints.

The valve is supported by the pipework system.

Detailed user information is enclosed for valves with power actuators and attachments with
safety function (sensor, switch, solenoid valve, etc.).

The valve must be protected against dirt and damage during construction work.

Remove any transport locks such as blocking bushing (optional).

Check the leak-tightness.