HERO SPLENDOR PRO, Руководство пользователя

Страница: 48 / 68

45
STOP LAMP SWITCH
The stop lamp switch (1) must be adjusted so
that stop lamp will glow when rear brake is
applied. Rear brake pedal free play (page 41 &
42) should be adjusted before performing stop
lamp switch adjustment. The procedure for
adjusting stop lamp switch is as follows:
1. Turn the ignition switch to the “ON”
position.
2. Turn the adjusting nut (2) to position stop
lamp switch at a point where the stop
lamp will glow just before the brake
pedal is depressed to the limit of its free
Fuse Type :
Blade fuse
Spare fuse (3) : 15A, 10A
In circuit fuse (2) : 15A, 10A
2 3
4
1
FUSE REPLACEMENT
Fuse Box
(1) : Location : Mounted on the
clamp near battery (4).
Never use a fuse with a different rating
from that specified. It may lead to
serious damage to the electrical system
or a fire due to short circuit.
Battery gives off explosive gases. Keep
sparks, flames & cigarettes away.
Do not attempt to start or ride the
motorcycle without a charged battery, it
can cause fusing of the bulbs and permanent
damage to certain electrical components.
Turn the ignition switch "OFF" before
checking or replacing the fuse to
prevent accidental short-circuiting.
CAUTION
2. Check all bolts and other fasteners are
secure.
5. Pull out the battery from the battery box.
4. Remove the battery clamp bolt (page
43).
Battery installation
1. Reinstall in the reverse order of removal.
Be sure to connect the positive (+)
terminal first, then the negative (-)
terminal.