22
•
Fuel
level-
Ensure sufficient fuel is available
in
your
fuel tank for
journey
. Fuel level
gauge needle should be above red band
(page
19
)
. Check for leaks.
•
Front brake (Disc type)-
Check for
correct brake fluid level in the master
cylinder
(page
44
).
•
i3s switch
-Make sure whether the i3s
switch is in “ON” or “OFF” position
(page 17).
•
Lamps and Horn-
Check that headlamp,
tail/stop lamp, turn signal
lamps and horn
function properly.
•
Front and Integrated b
rak
es
(D
rum
type)
-
C
heck operation. Adjust free play if
necessary
(page
45
).
•
Drive chain-
Check condition and
slackness
(page 41).
Adjust and lubricate if
necessary.
•
i3s system
-Make sure that i3s system is
functional properly
(page 17).
•
Tyres-
Check condition and pressure
(page
52
)
.
•
Rear brake-
Check operation. Adjust free
play if necessary
(page 4
7
)
.
•
Clutch-
Check for smooth operation.
Adjust free play
(page 40)
.
•
Rear view mirror-
Ensure that the rear
view mirror gives a good rear view when you
are sitting on the vehicle.
•
Throttle-
Check for smooth opening and
closing in all steering positions
(page 41)
.
•
Any personal belongings have to be removed
before water washing to avoid damage.
•
Always keep the USB port cap closed after
use to prevent dust or water entry during
rains/water wash.
•
Do not apply any soap solution, oil or grease
inside the USB charger.
•
Do not direct water jet towards the port even
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
NOTE
PRE-RIDE INSPECTION
You should conduct pre
-
ride inspection
before riding the vehicle to enhance riding
comfort and safety.
Clean your vehicle
regularly. It protects the surface finish. Avoid
cleaning with products that are not specifically
designed for
vehicle
surfaces
.
Inspect your
vehicle
very day before you start the engine.
The items listed here will only take a few
minutes, and in the long run they can save
time, expense and possibly your
life. Please
follow the tips as given below:
•
Engine oil level-
Check and top up engine
oil if required
(page
33
).
Check for leaks.
•
Programmed FI malfunction indicator
lamp (MIL)
-When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp (MIL) glows
continuously and then should go “OFF”
once the engine is started.
