Hermann Bock practico ultra low 9.5/80, Инструкция по установке и эксплуатации

Страница: 22 / 40

22
Next, screw the end panel with the broad intake
into the supporting girders at the head end and
screw it together with hexagon socket screws
(M8x25). The appropriate screws are located in
the rectangular bar at the intake. Next, repeat
step (3) on the head part.
For installation of cable connections, remove
some strips from the lying surface. It makes it
easier to access the cable canals.
Remove the cover of the (1) cable channels,
which open the (2) pull reliefs and insert the
connecting plug of the lifting column.
Additionally, run the mains cable from the end
piece of the head part through the cable channel
and connect it to the back of the control box.
Next, place (press) the supplied plastic part onto
the control box’s power plug.
Place the cable of the lifting column from the
head part and the power supply cable in the
cable channel, in which also the hand switch
cable is located. Guide the cable of the lifting
column from the foot part is through the still
unused cable channel all the way to the control.
Fix this cable at the angle bracket with a cable
tie.
Close the cable channels again completely to
prevent any cable falling out. As the surface can
be lowered to almost floor level, there is an
increased risk of squeezing the cables.