HermanMiller
Assembly Instructions
3
1BKWR9 rev B
3.1 Align corner of External Acoustic Pad by mating top edge of loop strip
on back of Pad with top edge of side panel. Mate Loop strip side edge with
vertical rail edge.
3.2 Hold External Acoustic Pad edge against rail. Press onto side panel.
3.3 Repeat for other side of panel. Note: top edge of pad should be 1/4”
above top edge of side panel.
3.4 Press fi rmly from top to bottom over pad side edges to make sure hook
and loop strips are fully engaged and to provide extra pressure to hook strip
adhesive.
Step 2
Step 3
External Acoustic Pad
Rail Edge
Side Panel Top Edge
2.1 Peel protective fi lm from Hook layer.
2.2 Align top edge of hook strip with top edge of side panel.
2.3 Adhere to side panel with a 3mm gap between Vertical Rail and Hook Strip.
2.4 Press Hook Strips fi rmly against side panel along entire length of both
strips. This is critical for good adhesive bond to side panel.
2.5 Install all hook strips for all panels fi rst, moving in a circular movement
around unit. Once all hook strips are are installed, begin installing pads. Start
with fi rst set of hook strips that were installed. Move in same direction as the
hook strips were installed.
Hook Strip
Hook Strip
Top of Side Panel
Vertical Rail
Vertical Rail
Top of Hook Strip
Top of Hook Strip
Top of Pad
Top of Rail
1/4”
Creative/Media Space - Outside Pad:
Loop Strip on Spacer
Loop Strip on Spacer
External Acoustic Pad
Top Edge of Loop Strip
Top Edge of Loop Strip
1.1 Hook Strips will be separate from Loop Strips on External Acoustical Pad.
Hook Strips
