HermanMiller
Assembly Instructions
6
1BN38L rev C
Disassembly and Recycling:
Materials Identification and Segregation:
Where possible, plastic components are marked with ASTM recycling
codes. Use these codes to identify material type for recycling. Non marked
components should be treated as mixed plastic. Ferrous metals can be
identified using a small magnet for recycling. Non-ferrous metals should be
separated and recycled separately.
To disassemble product, reverse the above installation steps.
Step 9
9.1 After the cladding is attached to the wall, a monitor mounting
bracket is installed on the mounting board.
9.2 Customers will need to provide the monitor mounting bracket that
attaches to the mounting boards.
9.3 A monitor mounting bracket like the Sanus VMPL3 Dual Purpose
Wall Mount is recommended.
When the Monitor Mount is used on the exterior of the application, such as
a Space Delineation application (shown below), there are specific weight
limitations that the monitor and monitor mount cannot exceed. These are
dependent on the materials used with the Spanner Returns (MN400.). See
below:
There are is no minimum weight limit based on materials used in the Spanner
Zone with then Monitor is mounting on the inside of the application when
used with a Return Spanner (MN400.R) or a Column Spanner (MN400.P). The
Maximum weight the monitors and mounts cannot exceed 165 lbs. per side.
Media Mounting
Two 4’ 0” Returns
One 4 ‘ 0” Return & One 6’ 0”
Return
Two 6’ 0” Returns
Weight Limit of
165 lbs..
for any
combination of Spanner Zone
Laminate Cladding, Wood Slats, or
Perforated Metal.
Weight limit of
75 lbs..
w hen both of
the Return Spanners (MN400.R) use
Spanner Zone Tackable Cladding.
Weight Limit of
165 lbs..
for any
combination of Spanner Zone
Cladding, Wood Slats, or Perforated
Metal.
No Monitor can be mounted on the
outside of the Performance Wall
Cladding if the Return Spanners
(MN400.R) use Spanner Zone
Tackable Cladding.
Weight Limit of
165 lbs..
for any
combination of Spanner Zone
Laminate Cladding, Wood Slats, or
Perforated Metal.
